This is an old revision of the document!
Data file import
Create a new workspace or open an existing one:
Then select Import Files. A new dialog opens, where the data file is selected:
The file selected above is a sample data file, Decay_Coumarin_6.phu
installed during the installation of the native TimeHarp260 software. This file contains two histograms: an Instrument Response Function (IRF) and a decay curve of Coumarin6 dissolved in ethanol. During file import, before pressing the Open button, it is possible to preview and step through the data content of selected file using the control elements on the right hand side of the dialog.
The same data file, when opened in the native software, looks like this:
Trace #0 shows the IRF, Trace #2 is the decay curve. The other data blocks are empty. Both Trace #0 and #2 will be imported into a single .etc
data container. This will make the data analysis easier. In general, such a .phu
file may contain many more histograms.
It is also possible that an IRF measurement and a decay measurement are stored in two separate .phu
files. This is no problem, but then the file import procedure has to be repeated for each file and the imported curves will end up in dedicated .etc
data containers.
After importing Decay_Coumarin_6.phu
, the workspace looks like this:
After expanding the data container:
Two histograms have been imported. They are shown as “Decay” because EasyTau does not know their assignment yet.