support:tcspc_external_markers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
support:tcspc_external_markers [2017/05/17 08:31] – admin | support:tcspc_external_markers [2019/07/09 13:39] – oschulz | ||
---|---|---|---|
Line 21: | Line 21: | ||
* PicoHarp manual: | * PicoHarp manual: | ||
* HydraHarp manual: | * HydraHarp manual: | ||
- | * TimeHarp manual: | + | * TimeHarp manual: |
+ | * MultiHarp manual: Check pages 33-34, 57 and 69-71. \\ | ||
====Step 3: Make the connection==== | ====Step 3: Make the connection==== | ||
Line 27: | Line 28: | ||
Probably this mean that you have to construct a cable your self. | Probably this mean that you have to construct a cable your self. | ||
Please note that PicoQuant has the proper cables for \\ | Please note that PicoQuant has the proper cables for \\ | ||
- | PI Controller: E725 \\ | + | * [[ https:// |
- | PI Controller: E710 \\ | + | * PI Controller: E725 |
- | which[[http:// | + | |
+ | which have been used in PicoQuant systems before | ||
Line 37: | Line 39: | ||
__**The " | __**The " | ||
Assuming that you get the cable connection etc. You will be able to work in T3 mode , markers will be registered in the raw data but still you will have to construct a home - build software if you want to have some online preview on the image while scanning and also extract the data you would like to use during the analysis. | Assuming that you get the cable connection etc. You will be able to work in T3 mode , markers will be registered in the raw data but still you will have to construct a home - build software if you want to have some online preview on the image while scanning and also extract the data you would like to use during the analysis. | ||
- | For this you should use the DLL of the corresponding TCSPC module and control its acquisition parameters. Please note that the DLL option is enabled by default only for the HydraHarp and should be purchased as a seperate module for the Timearp | + | For this you should use the DLL of the corresponding TCSPC module and control its acquisition parameters. Please note that the DLL option is enabled by default only for the HydraHarp |
\\ | \\ |
support/tcspc_external_markers.txt · Last modified: 2020/09/14 16:01 by sisamakis