Time-Resolved Fluorescence Wiki

User Tools

Site Tools

Trace:
howto:antibunching_measurements

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Last revisionBoth sides next revision
howto:antibunching_measurements [2023/09/07 11:50] – [Changing from Normal Acquisition (T3-mode) to Antibunching (T2-mode)] peterhowto:antibunching_measurements [2023/09/07 11:52] – [Changing from Normal Acquisition (T3-mode) to Antibunching (T2-mode)] peter
Line 36: Line 36:
      -Adjustment of the CFD Level for Ch 0 (Sync Channel) might be necessary.       -Adjustment of the CFD Level for Ch 0 (Sync Channel) might be necessary. 
  
-    *It is also possible to connect both Detectors directly to the [[Products:PicoHarp 300]] without passing SPAD 2 through the router.    **In this case, however, the router cable (DVI-cable) needs to be disconnected from the PH300** +It is also possible to connect both detectors directly to the [[Products:PicoHarp 300]] without passing SPAD 2 through the router. **In this case, however, the router cable (DVI-cable) needs to be disconnected from PicoHarp300** 
-    *No special delay cables necessary +  
  
 === Cabling: HydraHarp === === Cabling: HydraHarp ===
howto/antibunching_measurements.txt · Last modified: 2023/09/07 11:54 by peter