Time-Resolved Fluorescence Wiki

User Tools

Site Tools

Trace:
howto:antibunching_measurements

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
howto:antibunching_measurements [2023/09/07 11:43] – [Antibunching using SymPhoTime] peterhowto:antibunching_measurements [2023/09/07 11:50] – [Changing from Normal Acquisition (T3-mode) to Antibunching (T2-mode)] peter
Line 31: Line 31:
 === Cabling: PicoHarp === === Cabling: PicoHarp ===
  
-     -Disconnect Sync from [[Products:PicoHarp 300]] Ch0. +     -Disconnect Sync from [[Products:PicoHarp 300]] Ch.0. 
-     -Disconnect SPAD 1 Signal from Router ([[Products:PHR800]]). +     -Disconnect SPAD 1 Signal from PHR800 Router. 
-     -Connect SPAD 1 to [[Products:PicoHarp 300]] Ch0 (Do not use the attenuator).+     -Connect SPAD 1 Signal to [[Products:PicoHarp 300]] Ch.0 only if it is NIM compatible. If the SPAD provides only TTL output pulses, you need to use the SIA400 adapter.
      -Adjustment of the CFD Level for Ch 0 (Sync Channel) might be necessary.       -Adjustment of the CFD Level for Ch 0 (Sync Channel) might be necessary. 
  
howto/antibunching_measurements.txt · Last modified: 2023/09/07 11:54 by peter