Differences

This shows you the differences between two versions of the page.

--- howto:antibunching_measurements [2015/01/22 14:57] – admin
+++ howto:antibunching_measurements [2015/01/22 15:00] – admin
@@ Line 14: / Line 14: @@
     *with [[Products:PicoHarp 300]] in [[glossary:T3-mode]]
-        *not possible with the [[Products:SymPhoTime#SymPhoTime32]], because in [[Products:SymPhoTime#SymPhoTime32]] the [[Glossary:Sync Divider]] is always active and set to 8
+        *not possible with the [[software:SymPhoTime32]], because in [[software:SymPhoTime32]] the [[Glossary:Sync Divider]] is always active and set to 8
-        *data acquisition is possible with the [[Products:PicoHarp 300]]/[[Products:HydraHarp 400]] software as well as with [[Products:SymPhoTime#SymPhoTime64]], where the sync divider can be disabled. With HH, don't use use SYNC channel as input for one detector, but e.g. Ch. 1+2. SYNC must be plugged in. Unfortunately, analysis of HH T3-antibunching data is not implemented in SPT.
+        *data acquisition is possible with the [[Products:PicoHarp 300]]/[[Products:HydraHarp 400]] software as well as with [[software:SymPhoTime64]], where the sync divider can be disabled. With HH, don't use use SYNC channel as input for one detector, but e.g. Ch. 1+2. SYNC must be plugged in. Unfortunately, analysis of HH T3-antibunching data is not implemented in SPT.
     *with [[Products:PicoHarp 300]]/[[Products:HydraHarp 400]] in [[glossary:T2-mode]]
-        *measurements are possible with the [[Products:SymPhoTime]]
+        *measurements are possible with the [[software:SymPhoTime64]]
 ==== Changing from Normal Acquisition (T3-mode) to Antibunching (T2-mode) ====