howto:antibunching_measurements
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
howto:antibunching_measurements [2023/09/07 11:52] – [Changing from Normal Acquisition (T3-mode) to Antibunching (T2-mode)] peter | howto:antibunching_measurements [2023/09/07 11:54] (current) – [Changing from Normal Acquisition (T3-mode) to Antibunching (T2-mode)] peter | ||
---|---|---|---|
Line 29: | Line 29: | ||
==== Changing from Normal Acquisition (T3-mode) to Antibunching (T2-mode) ==== | ==== Changing from Normal Acquisition (T3-mode) to Antibunching (T2-mode) ==== | ||
| | ||
- | === Cabling: PicoHarp === | + | === Cabling: PicoHarp |
| | ||
Line 39: | Line 39: | ||
| | ||
- | === Cabling: HydraHarp === | + | === Cabling: HydraHarp |
- | *Disconnect Sync from [[Products: | + | *Disconnect |
- | *if Laser is attached via [[Products: | + | *if the laser is an LDH-series heasd driven by [[Products: |
=== Software Settings during Acquisition === | === Software Settings during Acquisition === |
howto/antibunching_measurements.txt · Last modified: 2023/09/07 11:54 by peter