Differences

This shows you the differences between two versions of the page.

--- howto:antibunching_measurements [2023/09/07 11:34] – [Antibunching using SymPhoTime] peter
+++ howto:antibunching_measurements [2023/09/07 11:50] – [Changing from Normal Acquisition (T3-mode) to Antibunching (T2-mode)] peter
@@ Line 16: / Line 16: @@
     *with [[Products:PicoHarp 300]] in [[glossary:T3-mode]]
         *not possible with SymPhoTime (32-bit version), because in SPT32 the Sync Divider is always active and set to 8
-        *instead, data acquisition is possible with native [[Products:PicoHarp 300]]/[[Products:HydraHarp 400]] softwares as well as with [[software:SymPhoTime64]], where the sync divider can be disabled. With a HydraHarp400, don't use use SYNC channel as input for one detector. Use e.g. input channels 1 and 2. SYNC signal must be disconnected. Unfortunately, analysis of HH T3-antibunching data is not implemented in SPT.
+Instead, data acquisition is possible with native [[Products:PicoHarp 300]]/[[Products:HydraHarp 400]] softwares as well as with [[software:SymPhoTime64]], where the sync divider can be disabled.
+Using a PicoHarp300, connect one detector to Ch.0 (SYNC) and the other one to Ch.1
+With a HydraHarp400, don't use use SYNC channel as input for one detector. Use e.g. input channels 1 and 2. The SYNC should stay connected.
+Unfortunately, analysis of HydraHarp400 T3-mode antibunching data is not implemented in SPT.
     *with [[Products:PicoHarp 300]]/[[Products:HydraHarp 400]] in [[glossary:T2-mode]]
-        *measurements are possible with the [[software:SymPhoTime64]]
+        *measurements are possible with [[software:SymPhoTime64]]
 ==== Changing from Normal Acquisition (T3-mode) to Antibunching (T2-mode) ====
@@ Line 24: / Line 31: @@
 === Cabling: PicoHarp ===
-     -Disconnect Sync from [[Products:PicoHarp 300]] Ch0.
+     -Disconnect Sync from [[Products:PicoHarp 300]] Ch.0.
-     -Disconnect SPAD 1 Signal from Router ([[Products:PHR800]]).
+     -Disconnect SPAD 1 Signal from PHR800 Router.
-     -Connect SPAD 1 to [[Products:PicoHarp 300]] Ch0 (Do not use the attenuator).
+     -Connect SPAD 1 Signal to [[Products:PicoHarp 300]] Ch.0 only if it is NIM compatible. If the SPAD provides only TTL output pulses, you need to use the SIA400 adapter.
      -Adjustment of the CFD Level for Ch 0 (Sync Channel) might be necessary.