Differences

This shows you the differences between two versions of the page.

--- howto:antibunching_measurements [2023/09/07 11:34] – [Antibunching using SymPhoTime] peter
+++ howto:antibunching_measurements [2023/09/07 11:43] – [Antibunching using SymPhoTime] peter
@@ Line 16: / Line 16: @@
     *with [[Products:PicoHarp 300]] in [[glossary:T3-mode]]
         *not possible with SymPhoTime (32-bit version), because in SPT32 the Sync Divider is always active and set to 8
-        *instead, data acquisition is possible with native [[Products:PicoHarp 300]]/[[Products:HydraHarp 400]] softwares as well as with [[software:SymPhoTime64]], where the sync divider can be disabled. With a HydraHarp400, don't use use SYNC channel as input for one detector. Use e.g. input channels 1 and 2. SYNC signal must be disconnected. Unfortunately, analysis of HH T3-antibunching data is not implemented in SPT.
+Instead, data acquisition is possible with native [[Products:PicoHarp 300]]/[[Products:HydraHarp 400]] softwares as well as with [[software:SymPhoTime64]], where the sync divider can be disabled.
+Using a PicoHarp300, connect one detector to Ch.0 (SYNC) and the other one to Ch.1
+With a HydraHarp400, don't use use SYNC channel as input for one detector. Use e.g. input channels 1 and 2. The SYNC should stay connected.
+Unfortunately, analysis of HydraHarp400 T3-mode antibunching data is not implemented in SPT.
     *with [[Products:PicoHarp 300]]/[[Products:HydraHarp 400]] in [[glossary:T2-mode]]
-        *measurements are possible with the [[software:SymPhoTime64]]
+        *measurements are possible with [[software:SymPhoTime64]]
 ==== Changing from Normal Acquisition (T3-mode) to Antibunching (T2-mode) ====