Supported MT200 PC and Hardware Configuration for SymPhoTime 64
NOTE: When upgrading your system we strongly encourage you to do so by purchasing a pre-tested PC from PicoQuant. While we try our best to support custom PC setups we cannot guarantee that all the components will work together.
Supported OS
Win10: YES
Win8: YES
Win7 64bit: YES
Win7 32bit: NO
WinXP: NO
Supported Hardware (for MicroTime200):
Harps (TCSPC units)
PicoHarp 300
For imaging, only supported with Router PHR800
Supported for point measurements (e.g. FCS)
HydraHarp 400
Fully supported with firmware version 2.xx and higher
TimeHarp 260 (Pico Dual and Nano Dual)
Fully supported
MultiHarp 150
Fully supported
Scanner (tested)
Controller: E727
Controller: E725
Controller: E710
Controller: C867.2U2 (PI wide range scanner)
Controller: C867.262 (PI wide range scanner)
xy-Stage: P733
z-Stage: Pifoc P725
PicoQuant FLIMbee galvo scanner
Scanner (not tested by PicoQuant Support)
MadCityLabs created a DLL which allows SymPhoTime 64 to use a specific MCL scanner. The support for this scanner is entirely handled by MadcityLabs and not by PicoQuant.
Brightfield Camera
IDS UI-3370CP-NIR-GL 1“ monochrome camera 2048×2048
CAN & Frame Grabber
Matrix Vision PCIe Framegrabber https://www.picoquant.com/dl_software/MT200_Driver/mvDELTA_mvSIGMA-x86_64-2.18.3.zip Note: Driver changed in SPTv2.3: New driver may affect the brignthness of the camera image. SPT versions v0.0 - v2.2 are incompatible with the new driver, SPT versions v2.3 - … are incompatible with the old driver. (Incompatibility leads to a frozen splash screen.)